Interlogix NS4750-24S-4T-4X-V2 Command Manual page 154

Chapter 4: Commands for CLI configuration
<Mepid : uint>
last-n The last N dalays used for average last N calculation. Min value is 10.
<Lastn : uint>
Default:
0
Usage Guide:
To configure Delay Measurement of MEP
Example:
To configure Delay Measurement of MEP 1 as below table.
Switch# configure terminal
Switch (config)# mep 1 dm 5 rdtrp interval 10 last-n 10
mep <Instance> dm ns
Command:
mep <Instance> dm ns
mep Maintenance Entity Point
<Instance> The MEP instance number.
dm Delay Measurement
ns Nano Seconds
Default:
us
Usage Guide:
To configure Delay Measurement of MEP
Example:
To configure Delay Measurement unit (ns) of MEP 1 as below table.
Switch# configure terminal
Switch (config)# mep 1 dm ns
mep <Instance> dm overflow-reset
Command:
mep <Instance> dm overflow-reset
mep Maintenance Entity Point
<Instance> The MEP instance number.
152
Peer MEP-ID value
The last N value
NS4750-24S-4T-4X-V2 Managed Switch Command Guide