Interlogix NS4750-24S-4T-4X-V2 Command Manual page 125

Default:
Disabled
Usage Guide:
To enable IGMP Snooping for specific VLAN.
Example:
To enable IGMP Snooping for VLAN 1.
Switch# configure terminal
Switch (config)# ip igmp snooping vlan 1
ip igmp ssm-range
Command:
ip igmp ssm-range <ipv4_mcast> <Ipv4PrefixLength : 4-32>
ip Internet Protocol
igmp Internet Group Management Protocol
ssm-range IPv4 address range of Source Specific Multicast
<ipv4_mcast>
<vlan_list> VLAN identifier(s): VID
<Ipv4PrefixLength : 4-32>
Default:
232.0.0.0/8
Usage Guide:
To enable SSM Range of IGMP.
Example:
To enable SSM Range (239.239.239.239/32) of IGMP.
Switch# configure terminal
Switch (config)# ip igmp ssm-range 239.239.239.239 32
ip igmp unknown-flooding
Command:
ip igmp unknown-flooding
ip Internet Protocol
igmp Internet Group Management Protocol
unknown-flooding
Default:
Enabled
Usage Guide:
To flood unregistered IPv4 multicast traffic.
Example:
To flood unregistered IPv4 multicast traffic.
Switch# configure terminal
NS4750-24S-4T-4X-V2 Managed Switch Command Guide
Valid IPv4 multicast address
Prefix length ranges from 4 to 32
Flooding unregistered IPv4 multicast traffic
Chapter 4: Commands for CLI configuration
123