Interlogix NS4750-24S-4T-4X-V2 Command Manual page 159

Usage Guide:
To configure Loss Measurement of MEP.
Example:
To configure Loss Measurement of MEP 2 as below table
Switch# configure terminal
Switch (config)# mep 2 lm 5 uni flr 4
mep <Instance> lt
Command:
mep <Instance> lt <prio> { { mep-id <mepid> } | { mac
<mac> } } ttl <ttl>
mep Maintenance Entity Point
<Instance> The MEP instance number.
lt Link Trace
<Prio : 0-7>
ID.
mac Link Trace target unicast MAC to be used in case of LT against MIP.
<Mac : mac_addr>
mep-id Peer MEP-ID for Link Trace target unicast MAC. The MAC is taken from
peer MEP MAC database.
<Mepid : uint>
ttl Time To Live.
<Ttl : uint> Time To Live value
Default:
Usage Guide:
To configure Link Trace of MEP.
Example:
To configure Link Trace of MEP 1 as below table
Switch# configure terminal
Switch (config)# mep 1 lt 4 mac 11-3A-15-A3-53-44
mep <Instance> meg-id
Command:
NS4750-24S-4T-4X-V2 Managed Switch Command Guide
Priority in case of tagged OAM. In the EVC domain this is the COS-
Link Trace target unicast MAC value.
Peer MEP-ID value.
Chapter 4: Commands for CLI configuration
157