Interlogix NS4750-24S-4T-4X-V2 Command Manual page 142

Chapter 4: Commands for CLI configuration
Default:
0
Usage Guide:
To configure width of the display terminal.
Example:
To configure width (50) of the display terminal for vty 1.
Switch# configure terminal
Switch (config)# line vty 1
Switch (config-line)# width 50
lldp holdtime
Command:
lldp holdtime <2-10>
lldp LLDP configurations.
holdtime Sets LLDP hold time (The neighbor switch will discarded the LLDP
information after "hold time" multiplied with "timer" seconds ).
<2-10> 2-10 seconds
Default:
4
Usage Guide:
To enable LLDP hold time
Example:
To enable LLDP hold time (5)
Switch# configure terminal
Switch (config)# lldp holdtime 5
lldp med datum
Command:
lldp med datum nad83-mllw | nad83-navd88 | wgs84
lldp LLDP configurations.
med Media Endpoint Discovery
datum Datum (geodetic system) type
nad83-mllw
nad83-navd88
wgs84 World Geodetic System 1984
Default:
WGS84
Usage Guide:
To configure Datum type of LLDP
Example:
To configure Datum type (nad83-mllw) of LLDP
140
Mean lower low water datum 1983
North American vertical datum 1983
NS4750-24S-4T-4X-V2 Managed Switch Command Guide