Interlogix NS4750-24S-4T-4X-V2 Command Manual page 35

0
Usage Guide:
To set pps rate for all rate-limiter ID.
Example:
To set pps rate(10000 pps) for all rate-limiter ID.
Switch# configure terminal
Switch (config)# access-list rate-limiter pps 100
aggregation mode
Command:
aggregation mode dmac | ip | port | smac
dmac Destination MAC affects the distribution
ip IP address affects the distribution
port IP port affects the distribution
smac Source MAC affects the distribution
Default:
SMAC : Enabled
DMAC : Disabled
IP : Enabled
Port : Enabled
Usage Guide:
To configure static aggregation mode type.
Example:
To configure static aggregation mode type with Destination MAC affects the
distribution and Source MAC affects the distribution only.
Switch# configure terminal
Switch (config)# access-list rate-limiter pps 100
banner
Command:
banner <LINE>
<LINE> c banner-text c, where 'c' is a delimiting character
Default:
N/A
Usage Guide:
To configure banner-text.
Example:
To configure banner-text with word "ddddd".
Switch# configure terminal
Switch (config)# banner 1
Enter TEXT message. End with the character '1'.
NS4750-24S-4T-4X-V2 Managed Switch Command Guide
Chapter 4: Commands for CLI configuration
33