Interlogix NS4750-24S-4T-4X-V2 Command Manual page 56

Chapter 4: Commands for CLI configuration
dot1x re-authenticate
Command:
dot1x re-authenticate
dot1x IEEE Standard for port-based Network Access Control
re-authenticate
Default:
N/A
Usage Guide:
To restart 802.1X authentication process.
Example:
To restart 802.1X authentication process for GigabitEthernet X/X.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # dot1x re-authenticate
duplex
Command:
duplex auto | full | half
duplex Interface duplex
auto Auto negotiation of duplex mode.
full Forced full duplex.
half Forced half duplex.
Default:
Auto
Usage Guide:
To configure duplex mode for interface.
Example:
To configure auto duplex mode for GigabitEthernet X/X.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # duplex auto
end
Command:
end
end Go back to EXEC mode
Default:
Auto
Usage Guide:
To back to EXEC mode
Example:
To back to EXEC mode
54
Refresh (restart) 802.1X authentication process.
NS4750-24S-4T-4X-V2 Managed Switch Command Guide