Interlogix NS4750-24S-4T-4X-V2 Command Manual page 200

Chapter 4: Commands for CLI configuration
Switch# configure terminal
Switch (config)# switchport vlan mapping 1 3 5
tacacs-server deadtime
Command:
tacacs-server deadtime <minutes>
tacacs-server
deadtime Time to stop using a TACACS+ server that doesn't respond
<Minutes : 1-1440>
Default:
0
Usage Guide:
To configure the Deadtime of TACACS+ Server
Example:
To enable the Deadtime (6) of TACACS+ Server
Switch# configure terminal
Switch (config)# tacacs-server deadtime 6
tacacs-server host
Command:
tacacs-server host <host_name> [ port <port> ] [ timeout
<seconds> ] [ key <key> ]
tacacs-server
host Specify a TACACS+ server
<HostName : word1-255>
key Server specific key (overrides default)
port TCP port for TACACS+ server
<Port : 0-65535>
timeout Time to wait for this TACACS+ server to reply (overrides default)
<Seconds : 1-1000>
<Key : line1-63>
Default:
None
Usage Guide:
To configure the Host of TACACS+ Server
Example:
To enable the Host (below table) of TACACS+ Server
Switch# configure terminal
Switch (config)# tacacs-server host interlogix.com port 55
timeout 6 key 7788
198
Configure TACACS+
Time in minutes
Configure TACACS+
Hostname or IP address
TCP port number
Wait time in seconds
The shared key
NS4750-24S-4T-4X-V2 Managed Switch Command Guide