Chapter 4: Commands for CLI configuration
spanning-tree auto-edge
Command:
spanning-tree auto-edge
spanning-tree
auto-edge
Default:
Enabled
Usage Guide:
To enable Auto Edge of CIST Normal Port Configuration for specific interface
Example:
To enable Auto Edge of CIST Normal Port Configuration for GigabitEthernet
X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # spanning-tree auto-edge
spanning-tree bpdu-guard
Command:
spanning-tree bpdu-guard
spanning-tree
auto-edge
Default:
Disabled
Usage Guide:
To enable BPDU Guard of CIST Normal Port Configuration for specific interface
Example:
To enable BPDU Guard of CIST Normal Port Configuration for GigabitEthernet
X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # spanning-tree bpdu-guard
spanning-tree edge
Command:
spanning-tree edge
spanning-tree
edge
Default:
Non-Edge
Usage Guide:
To enable edge port of CIST Normal Port Configuration for specific interface
Example:
To enable edge port of CIST Normal Port Configuration for GigabitEthernet X/X
84
Spanning Tree protocol
Auto detects edge status
Spanning Tree protocol
Auto detects edge status
Spanning Tree protocol
Edge port
NS4750-24S-4T-4X-V2 Managed Switch Command Guide
Need help?
Do you have a question about the NS4750-24S-4T-4X-V2 and is the answer not in the manual?