Interlogix NS4750-24S-4T-4X-V2 Command Manual page 52

Chapter 4: Commands for CLI configuration
Example:
To configure ACL Port-state function for the GigabitEthernet X/X.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # access-list port-state
access-list rate-limiter
Command:
access-list rate-limiter <RateLimiterId : 1-16>
rate-limiter Rate limiter
<RateLimiterId : 1-16>
Default:
Disable
Usage Guide:
To apply Rate Limiter ID for the ACL.
Example:
To apply ACL Rate Limiter ID 1 for the GigabitEthernet X/X.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # access-list rate-limiter 1
access-list redirect interface
Command:
access-list redirect interface 10GigabitEthernet
<port_type_list> | GigabitEthernet <port_type_list>
redirect Redirect frame to specific port
Default:
Disable
Usage Guide:
To redirect frames to specific Port.
Example:
To redirect GigabitEthernet X/X frames to GigabitEthernet 1/2.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # access-list redirect interface
GigabitEthernet 1/2
access-list shutdown
Command:
access-list shutdown
shutdown Shut down incoming port. The shutdown feature only works when the
50
Rate limiter ID
packet length is less than 1518 (without VLAN tags).
NS4750-24S-4T-4X-V2 Managed Switch Command Guide