Interlogix NS4750-24S-4T-4X-V2 Command Manual page 158

Chapter 4: Commands for CLI configuration
To configure Locked Frame Rate (1 frame/sec) of MEP 2.
Switch# configure terminal
Switch (config)# mep 2 lck
Switch (config)# mep 2 lck fr1s
mep <Instance> level
Command:
mep <Instance> level <Level : 0-7>
mep Maintenance Entity Point
<Instance> The MEP instance number.
level The MEG level of the MEP
<Level : 0-7> The MEG level value
Default:
0
Usage Guide:
To configure MEG level of MEP.
Example:
To configure MEG level (2) of MEP 2.
Switch# configure terminal
Switch (config)# mep 2 level 2
mep <Instance> lm
Command:
mep <Instance> lm <prio> [ multi | uni ] [ single | dual ] [ fr10s
| fr1s | fr6m | fr1m | fr6h ] [ flr <flr> ]
mep Maintenance Entity Point
<Instance> The MEP instance number.
lm Loss Measurement
<Prio : 0-7>
ID.
fr10s Frame rate is 10 f/s.
fr1m Frame rate is 1 f/min.
fr1s Frame rate is 1 f/s.
fr6h Frame rate is 6 f/hour.
fr6m Frame rate is 6 f/min.
dual Dual ended LM is based on CCM PDU.
single Single ended LM is based on LMM/LMR PDU.
multi OAM PDU is transmitted with multicast MAC.
uni OAM PDU is transmitted with unicast MAC. The MAC is taken from peer
MEP MAC database. In case of LM there is only one peer MEP.
flr The Frame Loss Ratio interval.
<Flr : uint> The Frame Loss Ratio interval value.
Default:
156
Priority in case of tagged OAM. In the EVC domain this is the COS-
NS4750-24S-4T-4X-V2 Managed Switch Command Guide