Interlogix NS4750-24S-4T-4X-V2 Command Manual page 73

no
no Negate a command or set its defaults
Default:
N/A
Usage Guide:
To default the function for specific interface
Example:
To enable the function (network-clock synchronization ssm) for
GigabitEthernet X/X.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # no network-clock synchronization ssm
ping ip
Command:
ping ip <ipv4_addr> size <size: 2-1452>
ping The ping command allows you to test connectivity to a network host from the
ip ip
<ipv4_addr>
size size
<size: 2-1452>
Default:
N/A
Usage Guide:
To run Ping function for specific interface
Example:
To run Ping function (IP address: 10.10.10.10 with size 88 bytes) for
GigabitEthernet X/X.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # ping ip 10.10.10.10 size 88
port-security
Command:
port-security
port-security
Default:
Disabled
Usage Guide:
To enable Port-security for specific interface
Example:
To enable Port-security for GigabitEthernet X/X
NS4750-24S-4T-4X-V2 Managed Switch Command Guide
appliance
IP address
Default is 56 (excluding MAC, IP and ICMP headers)
Enable/disable port security per interface.
Chapter 4: Commands for CLI configuration
71