Interlogix NS4750-24S-4T-4X-V2 Command Manual page 54

Chapter 4: Commands for CLI configuration
do
Command:
do < exec commands >
do To run exec commands in config mode
Default:
N/A
Usage Guide:
To run exec commands in configure terminal mode
Example:
To run "show aaa" in configure terminal mode.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # do show aaa
console : local
telnet : local
ssh : local
http : local
dot1x guest-vlan
Command:
dot1x guest-vlan
dot1x IEEE Standard for port-based Network Access Control
guest-vlan Enables/disables guest VLAN
Default:
Disable
Usage Guide:
To enable Guest VLAN
Example:
To enable Guest VLAN for GigabitEthernet X/X.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # dot1x guest-vlan
dot1x port-control
Command:
dot1x port-control auto | force-authorized | force-
unauthorized | mac-based | multi | single
dot1x IEEE Standard for port-based Network Access Control
port-control
auto Port-based 802.1X Authentication
force-authorized
force-unauthorized
mac-based
52
Sets the port security state.
Port access is allowed
Port access is not allowed
Switch authenticates on behalf of the client
NS4750-24S-4T-4X-V2 Managed Switch Command Guide