Interlogix NS4750-24S-4T-4X-V2 Command Manual page 69

To enable system-name of LLDP TLV for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # lldp tlv-select system-name
lldp transmit
Command:
lldp transmit
lldp LLDP configurations
transmit Enable/Disabled transmision of LLDP frames.
Default:
Both (Tx +Rx)
Usage Guide:
To configure LLDP Tx only mode for specific interface
Example:
To configure LLDP Tx only mode for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # lldp transmit
loop-protect
Command:
loop-protect
loop-protect
Default:
Enabled
Usage Guide:
To enable loop-protect for specific interface
Example:
To enable loop-protect for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # loop-protect
loop-protect action
Command:
loop-protect action [log] [shutdown]
loop-protect
action Action if loop detected
log Generate log
shutdown Shutdown port
NS4750-24S-4T-4X-V2 Managed Switch Command Guide
Loop protection configuration
Loop protection configuration
Chapter 4: Commands for CLI configuration
67