Parameter
<mode>
Integer type.
0
1
<timeout>
Integer type. The range is 30-90 and the default value is 30. Unit: second.
<err>
Integer type. The error code of the operation. Please refer to Chapter 3 for details.
NOTES
1.
NV 73916 should be set as 277 to enable NIDD function.
2.
Non-IP data calls are supported for AP embedded and tethered RmNet calls only.
3.
Non-IP data calls are not supported for modem embedded calls.
2.1.4. AT+QCFGEXT="nipds" Send MO Non-IP Data
AT+QCFGEXT="nipds" Send MO Non-IP Data
Write Command
Configure the MO Non-IP data to be
sent:
AT+QCFGEXT="nipds",<mode>,<data
>[,<data_length>]
Parameter
<mode>
Integer type. Data format.
0
1
<data>
String type. The data to be sent.
<data_length>
Integer type. The data length to be sent. The range is 1-100. Unit: byte.
<err>
Integer type. The error code of the operation. Please refer to Chapter 3 for details.
BG96_NIDD_AT_Commands_Manual
If there is any other error, response:
ERROR
Close the NIDD connection.
Open the NIDD connection.
Response
OK
If there is an error related to ME functionality, response:
+CME ERROR: <err>
If there is any other error, response:
ERROR
ASCII format string.
HEX format string.
LTE Module Series
BG96 NIDD Commands Manual
8 / 13