Attach Flange Assembly To Fort - KidKraft Cedar Summit COPPER RIDGE PLAYSET Installation And Operating Instructions Manual

Step 51: Attach Flange Assembly to Fort
A: With a helper place the Flange Assembly flush to the Crowsnest on the fort as shown in fig. 51.1 and 51.2,
then pre-drill 1/8" pilot holes in the bottom 4 mounting locations on (223) Crowsnest Slide Top (approximate
spots where circles are on figure), making sure the pre-drilled holes are a minimum of 1" deep.
B: Attach Flange Assembly to (223) Crowsnest Slide Top Insert using 4 (S7) #12 x 2" Pan Screws (with #12
Screw Bezel) in the pre-drilled holes. (fig.51.1) Make sure the flat surfaces of the Flange Assembly are flush to
(222) Crowsnest Front and both sides of (262) Crownest Front Spacer as shown in (fig. 51.1 & 51.2 & 51.3)
C: Attach the Flange Assembly flush to (222) Crowsnest Front using 4 (S6) #12 x 1" Pan Screws (with #12
Screw Bezel) as shown in fig. 51.1 and to both 262 Crowsnest Front Spacers using 5 (S6) #12 x 1" Pan Screw
per board. (fig. 51.1)
Fig. 51.1
Inside View
the 4 holes need
to be pre-drilled
223
S6
x 5
S6
222
S7
w/ #12
Screw Bezel
w/ #12
Screw Bezel
Fig. 51.2
Outside View
S6
x 5
Hardware
14 x #12 x 1" Pan Screw
S6
4 x #12 x 2" Pan Screw
S7
8 x #12 Screw Bezel
FW6
96
262
222
Fig. 51.3
Top of slide
flush to (223)
Crowsnest
Slide Top
Bottom of
slide flush
to (222)
Crownest
Front
223
262