KidKraft Cedar Summit COPPER RIDGE PLAYSET Installation And Operating Instructions Manual page 30

Step 8: Join Swing and Slide Assemblies
Part 2
C: From inside the assembly, tight to both (072) Front Wall Panel and (063) Narrow Front Panel, halfway up the
assembly, 5/8" below the panel, loosely attach 1 (082) Side Joist to (072) Front Wall Panel and (063) Narrow Front
Panel Back with 3 (WB10) 5/16 x 2-5/8" Wafer Bolts (with flat washer and t-nut). Bolts are installed from inside
the assembly. Make sure (082) Side Joist is level then attach with 2 (S3) #8 x 2-1/2" Wood Screws and tighten
bolts. (fig. 8.3, 8.4 and 8.5)
D: From inside the assembly insert 3 t-nuts into the (073) Wall Back Panel as shown in fig. 8.4 then repeat Step
C to attach 1 (082) Side Joist to (062) Back Panel Narrow and (073) Wall Back Panel. (fig. 8.3 & 8.4)
Fig. 8.3
062
060
082
Fig. 8.4
S3
Wood Parts
2 x Side Joist 1-1/2 x 1-1/2 x 63"
082
073
072
063
5/16"
T-Nut(hidden)
5/16" Flat
Washer
082
8
4 x
6 x
3 x
071
Fig. 8.5
Note these 3 x 5/16" t-nuts
go into the back wall before
installing the joist
5/16"
T-Nut
WB10
Hardware
#8 x 2-1/2" Wood Screw
S3
5/16 x 2-5/8" Wafer Bolt
WB10
(5/16" flat washer, 5/16" t-nut)
5/16" t-nut
30 30
5/8"
082
5/16"
T-Nut
5/16" Flat
Washer
Panel
S3