Table of Contents
Advertisement
Step 42: Attach Flange Assembly to Fort
A: With a helper place the Flange Assembly flush to the top opening in (9214) End Slide Panel as shown in fig.
42.1 & 42.2, then pre-drill 1/8" pilot holes in the bottom 4 mounting locations (approximate spots where circles
are on figure), making sure the pre-drilled holes are a minimum of 2.5 cm (1") deep. (fig. 42.1)
B: Attach Flange Assembly to bottom of (9214) End Slide Panel opening using 4 (S7) #12 x 2" Pan Screws
(with #12 Screw Bezel) in the pre-drilled holes. (fig. 42.1) Make sure the flat surfaces of the Flange Assembly
are flush to the (9214) End Slide Panel as shown in fig. 42.3.
C: Attach the Flange Assembly flush to top of (9214) End Slide Panel opening using 4 (S6) #12 x 1" Pan
Screws (with #12 Screw Bezel) as shown in fig. 42.1 and to both sides using 5 (S6) #12 x 1" Pan Screws per
side. (fig. 42.1)
Fig. 42.1
V5, pg 180, fig 32.1 update image
Inside View
side
S6
x 5
Lower SL Insert
S6
w/ #12
Screw Bezel
w/ #12
Screw Bezel
S7
* take inside view
from an existing
instruction
the 4 holes need
to be pre-drilled
Hardware
14 x
#12 x 1" Pan Screw
S6
4 x
#12 x 2" Pan Screw
S7
8 x
#12 Screw Bezel
FW6
side
S6 x 5
Fig. 42.3
88
Fig. 42.2
Outside View
9214
flush to top of
the (9214) End
Slide Panel
flush to bottom
of the (9214) End
Slide Panel
* take inside view
from an existing
Advertisement
Table of Contents
