KidKraft Cedar Summit COPPER RIDGE PLAYSET Installation And Operating Instructions Manual page 27

Step 6: Slide Wall Assembly
Part 2
A: Place (062) Narrow Panel Back against the left side of (060) End Panel noticing panel orientation. The tops
and bottoms of the panels should be flush and panels square. Pre-drill with a 3/16" drill bit, then fasten (062)
Narrow Panel Back to (060) End Panel with 4 (WL5) 1/4 x 2-1/2" Wafer Lags. (Fig. 6.5, 6.6 and 6.8)
B: Place (063) Narrow Front Panel against the right side of (060) End Panel noticing panel orientation. The tops
and bottoms of the panels should be flush and panels square. Pre-drill with a 3/16" drill bit, then fasten (060) End
Panel to (063) Narrow Front Panel with 4 (WL5) 1/4 x 2-1/2" Wafer Lags. (Fig. 6.5, 6.7 and 6.8)
Fig. 6.6
Flush
062
Notice (062) Narrow
Back Panel overlaps
(060) End Panel
Fig. 6.8
WL5
Wood Parts
1 x Narrow Panel Back 1-1/4 x 21-1/2 x 92"
062
1 x 063 Narrow Front Panel 1-1/4 x 21-1/2 x 92"
Fig. 6.5
060
WL5
062
060
061
Flush
Hardware
8 x 1/4 x 2-1/2" Wafer Lag
WL5
5
27
Fig. 6.7
063
Notice (060) End Panel
overlaps (063) Narrow
Front Panel
WL5
Flush
060