Attach Flange Assembly To Fort - KidKraft BOULDER STATION Installation And Operating Instructions Manual

Step 36: Attach Flange Assembly to Fort
A: With a helper place the Flange Assembly flush to the Crowsnest on the fort as shown in fig. 36.1, then
pre-drill 1/8" pilot holes in the bottom 4 mounting locations on (2197) Floor Board (approximate spots where
circles are on figure), making sure the pre-drilled holes are a minimum of 1" deep.
B: Attach Flange Assembly to the Crowsnest through (2197) Floor Board and into (2345) Porch Floor End
using 4 (S7) #12 x 2" Pan Screws (with #12 Screw Bezel) in the pre-drilled holes. (fig. 36.1 and 36.2) Make
sure the flat surfaces of the Flange Assembly are flush to the Crowsnest as shown in fig. 36.5.
C: Attach the Flange Assembly flush to (2346) Porch Top End using 4 (S6) #12 x 1" Pan Screws (with #12
Screw Bezel) as shown in fig. 36.1 and 36.3 and to both (2338) Crowsnest Faces using 5 (S6) #12 x 1" Pan
Screws per board. (fig. 36.1, 36.4 and 36.6)
Fig.36.1
Flange
(hidden)
Assembly
2346
2338
(hidden)
Fig. 36.2
Top
Fig. 36.3
S6
Inside View
S7
#12 Screw
Bezel
Bottom
14 x
4 x
8 x
#12 Screw
Bezel
2338
(hidden)
S6
Sides
Fig. 36.4
2197
2345
Hardware
#12 x 1" Pan Screw
S6
#12 x 2" Pan Screw
S7
#12 Screw Bezel
87
2346
Fig. 36.6
2338
Outside View
Fig. 36.5
2338
Top of slide
flush to (2346)
Porch Top End
Bottom of
slide flush
with deck