Attach Flange Assembly To Fort - KidKraft Cedar Summit Canyon Ridge Installation And Operating Instructions Manual

Step 25: Attach Flange Assembly to Fort
A: With a helper place the Flange Assembly flush to the Crowsnest on the fort as shown in fig. 25.1 and 25.5,
then pre-drill 1/8" pilot holes in the bottom 4 mounting locations on (220) Crowsnest Gap Board (approximate
spots where circles are on figure), making sure the pre-drilled holes are a minimum of 1" deep.
B: Attach Flange Assembly to the Crowsnest through (220) Crowsnest Gap Board and into (202) Crowsnest
Front using 4 (S7) #12 x 2" Pan Screws (with #12 Screw Bezel) in the pre-drilled holes. (fig. 25.1 and 25.2)
Make sure the flat surfaces of the Flange Assembly are flush to the Crowsnest as shown in fig. 25.5.
C: Attach the Flange Assembly flush to (200) Crowsnest Top using 4 (S6) #12 x 1" Pan Screws (with #12
Screw Bezel) as shown in fig. 25.1 and 25.3 and to both (204) Crowsnest Spacers using 5 (S6) #12 x 1" Pan
Screw per board. (fig. 25.1 and 25.4)
Fig. 25.3
Fig. 25.1
S6
Flange
Assembly
S6
Sides
Fig. 25.4
204
(hidden)
Top
#12 Screw
Bezel
Inside View
#12 Screw
Bezel
S7
Fig. 25.2
Bottom
(hidden)
200
204
(hidden)
220
202
Hardware
14 x #12 x 1" Pan Screw
S6
4 x #12 x 2" Pan Screw
S7
8 x #12 Screw Bezel
68
Fig. 25.6
204
Outside View
Top of slide flush
to (200) Crowsnest
Top
Bottom of
slide flush
with deck
200
204
Fig. 25.5