Attach Crowsnest Sides - KidKraft Cedar Summit COPPER RIDGE PLAYSET Installation And Operating Instructions Manual

Step 23: Attach Crowsnest Sides
A: Remove previously installed (H12) Hex Bolt 1/4 x 3 (with flat washer, lock washer and t-nut) from Step 9, Nest
Joist Assembly.
B: Place (231) Crowsnest Bottom Side Back on the outside left of the assembly so that it lines up with the bolt
hole as shown in fig.23.1. Re-install bolt loosely.
C: Place 1 (232) Wall Board Support on the inside of (231) Crowsnest Bottom Side Back so that it's tight to the
wall panel and flush with the bottom of (231) Crowsnest Bottom Side Back. Loosely install 2 (H10) 1/4 x 2-1/4"
Hex Bolts (with lock washer, flat washer and t-nut). (Fig. 23.1 & 23.2)
D: Check to make sure the (231) Crowsnest Bottom Side Back is level and install 1 (S2) #8 x 1-1/2" Wood Screw
in the inside bottom hole as shown in Fig. 23.1 & 23.3. Tighten all bolts.
E: Repeat to install (233) Crowsnest Bottom Side Front on the right side of the assembly. (Fig. 23.1 & 23.3)
Fig. 23.1
Fig. 23.2
1/4" Flat
1/4" T-Nut
Washer
(hidden)
231
232
1/4" Flat
Washer
Wood Parts
1 x Crowsnest Bottom Side Back 15/16 x 5-1/4 x 35"
231
2 x Wall Board Support 1-1/4 x 2-3/8 x 10-1/2"
232
1 x Crowsnest Bottom Side Front 15/16 x 5-1/4 x 35"
233
H12
231
232
1/4" Lock
Washer
1/4" Lock
Washer
231
(hidden)
233
H10
1/4" T-Nut
Hardware
4 x 1/4 x 2-1/4" Hex Bolt
H10
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
2 x #8 x 1-1/2" Wood Screw
S2
56
233
Fig. 23.3
S2