KidKraft Cedar Summit COPPER RIDGE PLAYSET Installation And Operating Instructions Manual page 31

Step 9: Nest Joist Assembly
A: From inside the assembly measure 5/8" (15.9mm)
down from the top of the Wall Panels and place the
joist assembly so that the (052) Front Wall Tie and
(053) Back Wall Tie are tight to (071) Swing Wall
Panel as shown in fig. 9.1 and 9.2.
B: Install 1 (H10) 1/4 x 2-1/4" Hex Bolt (with lock
washer, flat washer and t-nut) into the inside holes on
each side of the assembly. In the outside holes loosely
install 1 (H12) 1/4 x 3" Hex Bolt on each side of the
assembly. These bolts will be tightened in a later step.
(Fig. 9.2)
C: Make sure that assembly is level and install 4
(S11) #8 x 2" Wood Screws into (052) Front Wall Tie
and (053) Back Wall Tie as shown in fig. 9.1 and 9.3.
1/4" Flat
Washer
1/4" Lock
Washer
Fig. 9.3
Fig. 9.2
Loosely
H12
attach
S11
4 x
2 x
2 x
Fig. 9.1
052
Hidden
1/4"
T-Nut
H10 Tighten this
bolt on each
side at this
step
10
Hardware
#8 x 2" Wood Screw
S11
1/4 x 2-1/4" Hex Bolt
H10
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
1/4 x 3" Hex Bolt
H12
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
31
053
10
5/8"
(15.9mm)
1/4" Flat
Washer
1/4" Lock
Washer