Join Swing And Slide Assemblies - KidKraft Cedar Summit COPPER RIDGE PLAYSET Installation And Operating Instructions Manual

Step 8: Join Swing and Slide Assemblies
Part 1
A: With at least two helpers lift the Slide Wall Assembly and Swing Wall Assembly so the (062) Narrow Panel
Back and (063) Narrow Front Panel meet with (073) Wall Panel Back and (072) Panel Front Wall and are tight
together as shown in fig. 8.1.
B: Make sure the assembly is square then on the inside of the assembly, tight to (060) End Panel and flush to
the bottom of the panels attach 1 (081) Floor Joist to (062) Narrow Panel Back and (083) Wall Panel Back and
a second (081) Floor Joist to (063) Narrow Front Panel and (072) Panel Front Wall with 4 (S7) #12 x 2" Pan
Screws per board. (fig. 8.1 and 8.2)
Fig. 8.1
Fig. 8.2
060
Tight
(both sides)
Wood Parts
2 x Floor Joist 1-1/4 x 3 x 40-3/4"
081
063
Slide Wall
Assembly
060
062
062
Flush
081
7
S7
x 4 per board
7
Hardware
8 x #12 x 2" Pan Screw
S7
29 29
Swing Wall
Assembly
071
073
072
073
081