Attach Elbow Assembly To Flange Assembly - KidKraft Cedar Summit COPPER RIDGE PLAYSET Installation And Operating Instructions Manual

Step 52: Attach Elbow Assembly to Flange Assembly
Note: Keep all bolts loose until further step.
A: Fit one of the Elbow Assemblies to the Flange Assembly by lining up the arrows on each assembly. Attach
Elbow Assembly to Flange Assembly using 6 (PB1) ¼ x 3/4" Pan Bolts and Square Lock Nut. (fig. 52.1, 52.2 and
52.3)
B: Attach one of the Elbow assemblies to another Elbow Assembly making sure to line up the arrows on each
assembly. Attach 6 (¼ x 12.7)mm Pan Bolt with Square Lock Nut. Repeat this instruction for 2 more. (fig. 52.2
and 52.3)
Use Quadrex Driver as a guide pin for each hole before inserting bolt.
Fig. 52.1
Fig. 52.3
Align each elbow using the
molded arrows.
Fig. 52.2
Top Slide Bolt Holes
Square
Lock Nut
Use a 7/16" open end
wrench for nuts
97
Use special driver provided
in locations where the curve
reach with a standard driver.
Elbow
Assembly
Quadrex Driver
of the elbow are difficult to
¼ x 12.7mm
Pan Bolt
Flange
Assembly
Other Parts
1 x Quadrex Driver
24 x 1/4 x 12.7mm Pan Bolt
24 x 1/4" Square Lock Nut