Attach Flange Assembly To Fort - KidKraft CASTLEWOOD Installation And Operating Instructions Manual

Step 31: Attach Flange Assembly to Fort
Part 1
A: With a helper place the Flange Assembly flush to the top opening in End Wall as shown in fig. 32.1 and
the Fort Guide, then pre-drill 1/8" pilot holes in (8935) Lower SL Insert for the 4 bottom mounting locations
(approximate spots where circles are on figure), making sure the pre-drilled holes are a minimum of 1" deep. (fig.
31.2)
B: Attach Flange Assembly to (8935) Lower SL Insert using 4 (S7) Pan Screws (with #12 Screw Bezel) in the
pre-drilled holes. (fig. 31.2) Make sure the flat surfaces of the Flange Assembly are flush to the End Wall and
(2602) Upper Jamb as shown in fig. 31.3.
C: Attach the Flange Assembly flush to bottom of (2769) Panel BT Frame using 4 (S6) Pan Screws (with #12
Screw Bezel) and to (2602) Upper Jamb and side of End Wall using 5 (S6) Pan Screws per side. (fig. 31.2)
Fig. 31.2
Flange
Inside View
Assembly
2602
8935
2769
S6
w/ #12 Screw
Bezel
S7
w/ #12 Screw
Bezel
Hardware
14 x Pan Screw
S6
4 x Pan Screw
S7
8 x #12 Screw Bezel
66
Fig. 31.1
Outside View
Side
Flange
Assembly
Side
S6
8935
(5 per side)
Fig. 31.3
2769
2602
Bottom of (2769)
Panel BT Frame
Bottom of
slide flush with
(8935) Lower
SL Insert