Attach Flange Assembly To Fort - KidKraft F24930 Installation And Operating Instructions Manual

Step 30: Attach Flange Assembly to Fort
Part 1
A: With a helper place the Flange Assembly flush to the top opening in (2622) End Panel Assembly as shown in
fig. 30.1, then pre-drill 1/8" pilot holes in (8935) Lower SL Insert for the 4 bottom mounting locations (approximate
spots where circles are on figure), making sure the pre-drilled holes are a minimum of 1" deep. (fig. 30.2)
B: Attach Flange Assembly to (8935) Lower SL Insert using 4 (S7) #12 x 2" Pan Screws (with #12 Screw Bezel)
in the pre-drilled holes. (fig. 30.2) Make sure the flat surfaces of the Flange Assembly are flush to the (2622)
End Panel Assembly and (2602) Upper Jamb as shown in fig. 30.3.
C: Attach the Flange Assembly flush to top of (2622) End Panel Assembly using 4 (S6) #12 x 1" Pan Screws
(with #12 Screw Bezel) and to (2602) Upper Jamb and side of (2622) End Panel Assembly using 5 (S6) #12 x 1"
Pan Screws per side. (fig. 30.2)
Fig. 30.2
Flange
Inside View
Assembly
2602
8935
Top
2622
S6
w/ #12 Screw
Bezel
S7
w/ #12 Screw
Bezel
Hardware
14 x #12 x 1" Pan Screw
S6
4 x #12 x 2" Pan Screw
S7
8 x #12 Screw Bezel
67
Fig. 30.1
Outside View
Side
Flange
Assembly
Side
S6
8935
(5 per side)
Fig. 30.3
Top
2622
2602
Top of (2622) End
Panel Assembly
opening
Bottom of
slide flush with
(8935) Lower
SL Insert