View Sample Sets - Waters Alliance e2695 Operator's Manual

The following table describes the icons used in the Run Samples screen.
Table 5–1: Icons in the Run Sample screen
Icon
2. Select the sample set you want to run, and then press one of the following screen keys to
perform the indicated tasks:
• Initial Conds – Starts the solvent management system at the initial conditions (specified
in the first line of the sample set) and begins equilibrating the temperature in the
sample heater/cooler and/or column heater (or column heater/cooler). When the
system is equilibrated, press the Run screen key.
• Run – Displays the selected sample set table (to view or edit). Use the screen keys to
modify the table as necessary.
3. Load the sample vials into the carousel(s) according to the locations specified in the sample
set (see "Load vials" on page
Tip: For information on adding new sample vials while the instrument is processing a
sample set, see
4. Press the Start screen key.
Requirement:
run. Ensure you prepared the separations module with the indicated solvent(s).
5. Press the Routine screen key to start a normal run.
Tip: To make a stat run, or modify a run in progress, see
on page 85.
5.1.2

View sample sets

You can display the Sample Set table in one of three views described below. Press the Next View
screen key to scroll from one view to another.
• Functional View – Displays the sample set with one function per line. This view gives you a
complete overview of the entire run, including vial ranges and any linked rows.
• Injection View – Displays the sample set with one injection per line (see
screen – Injection View" on page
lines associated with an injection. This list corresponds directly to the chromatograms
produced by the run.
68).
"Add new sample vials during a run" on page
The Run Samples screen appears with a list of the solvents required for the
84). Press the Injects Only screen key to display only the
February 27, 2018, 715003794 Rev. C
Page 83
Description
Separation method
Sample set
Sample template
68).
"Modify a sample set during a run"
figure "Sample Set