1.3.5
Vial presence
A light-emitting diode assembly searches for the presence of a vial before the needle moves to the
Draw position. This searching prevents air from being accidentally injected into the solvent stream
when a programmed vial position is accidentally left empty. See the Verify vial presence parameter
in
"Set configuration parameters" on page
1.3.6
Syringe assembly
The syringe assembly is located behind a front panel door for ease of access (see
assembly" on page
you can install a 25-µL, 100-µL, or 2500-µL syringe. See
procedure to change the syringe. Note that the separations module serial number is located on the
syringe mounting plate.
Figure 1–7: Syringe assembly
Syringe
47.
28). The separations module uses a standard 250-µL syringe; as an option,
February 27, 2018, 715003794 Rev. C
Page 28
"Replace the syringe" on page 137
figure "Syringe
for the