Waters Alliance e2695 Operator's Manual page 70

Figure 4–3: Sample set queue
The following table describes the functions of the parameters in the Status screen fields. You can
make changes only in the fields outlined with a solid border.
Table 4–1: Status screen parameters
Parameter
Method
Flow
System
Sample: Set
Sample: Current
Composition
S1 - S4
Degasser:
• Mode
• Vac pump
• Pressure
Valves V1 - V4
Description
Indicates the current separation method. When
you change any parameter in the Status
screen, this field changes to <direct>.
Indicates the current flow rate of the solvent
management system.
Indicates the current system pressure in psia,
bar, or kPa.
Indicates the user-specified sample
compartment temperature.
Indicates the current actual sample
compartment temperature.
Indicates the current solvent composition.
Indicates the status of the event switches on
the I/O connector.
Indicates the status of the in-line vacuum
degasser (if installed).
Selects the mode of operation: On, or Off.
Indicates whether the vacuum pump motor is
active or idle.
Current vacuum level in psia, bar, or kPa.
Graphically indicate the position of each of the
four valves in the sample management system.
February 27, 2018, 715003794 Rev. C
Page 70
Open Closed