Install Solvent Supply Tubing - Waters Alliance e2695 Operator's Manual

Figure B–7: A- and C-series detector drain routing with drip tray
B.2.3

Install solvent supply tubing

The tubing from the separations module to the solvent reservoirs is coiled and stored in front of the
separations module, near the syringe compartment. One end of the solvent tubing is connected (at
the factory) to the in-line vacuum degasser, which is connected to the GPV.
Each tube is marked with a letter (corresponding to each solvent reservoir) and a color-coded
label.
Table B–2: Solvent supply tubing identification
Solvent line label
A
B
C
D
Solvent line color
Yellow
Blue
Red
Green
February 27, 2018, 715003794 Rev. C
Page 199
Drain fitting location
on drip tray
Tube routing
End of tube
Syringe drip tray