Set Sample Parameter Values - Waters Alliance e2695 Operator's Manual

6.2.2

Set sample parameter values

To enter parameters in the Sample screen:
1. Press the Next or Prev screen key to display the Sample screen.
Figure 6–6: Sample screen
2. In the Sample screen, enter or select values in the Sample screen parameter fields.
The following table describes the parameters in the Sample screen.
Table 6–5: Sample parameters
Parameter
Sample Temperature Target
Sample Temperature Range
Sample Temperature
On error
Function
Specifies the temperature of
the sample heater/cooler (if
installed). To turn off the
heater/cooler, press the Clear
key.
Specifies the maximum
allowable deviation in sample
temperature. If the
temperature deviation
exceeds the range, the alarm
condition selected in the
adjacent box is triggered.
Specifies the response that
occurs when the sample
compartment temperature is
out of the specified range
during a run.
February 27, 2018, 715003794 Rev. C
Page 100
Value range
Ambient, 4 to 40 °C
in 1 °C increments
±10 °C
in ±1 °C increments
See table "Alarm responses"
on page 97.