Perform A Run From A Sample Template - Waters Alliance e2695 Operator's Manual

• Loading View – Displays the sample set with one vial per line (see
screen – Loading View" on page
carousel.
Figure 5–3: Sample Set screen – Injection View
Figure 5–4: Sample Set screen – Loading View
5.1.3

Perform a run from a sample template

You can perform an automated run in a standalone mode using a sample template stored in the
separations module. See
store a sample template. Screen prompts give you step-by-step directions to prepare for the run.
To run a sample template in a standalone mode:
1. In the Main screen, press the Run Samples screen key.
2. Select a sample template, and then press Enter.
3. Specify the number of samples to run, and then press the Continue screen key.
4. Enter the location of the first sample vial, and then press the Continue screen key.
Requirement:
84). This view shows you how to load samples in the
"Create a sample template" on page 117
You must use consecutive sample vials on one or more carousels.
February 27, 2018, 715003794 Rev. C
Page 84
figure "Sample Set
for the procedure to create and