Perform Direct Functions - Waters Alliance e2695 Operator's Manual

Table 4–1: Status screen parameters (continued)
Parameter
2410 and 410:
• Cell
• Col 1
• Col 2
1. Enabled if the optional column heater or column heater/cooler module is configured with the Waters 2414, 2410, or 410
detector.
4.4

Perform direct functions

The following figure outlines the procedure for using the front panel to set up the separations
module to perform a direct function.
Figure 4–4: Steps to setting up a direct control run
Press the Menu/
Status key
Select the separation
method, or enter
parameter values in
the Status screen
Press the Direct
Function
screen key
To access the direct control functions:
1. Press Menu/Status to display the Status screen (see
on page 69
2. Press the Direct Function screen key. A list of direct functions appears.
3. From the list of direct functions, select the function you want to specify, and then press
Enter.
Select the direct
function to perform
Enter the function
parameters
The function begins
to run
and figure "Second page of the Status screen" on page
February 27, 2018, 715003794 Rev. C
Page 72
Description
Indicates the current status of the following
parameters for the 2414, 2410, or 410 detector
(if so installed):
• Cell Temperature (detector oven
temperature)
1
• External Temp 1
1
• External Temp 2
figure "First page of the Status screen"
69).