Waters Alliance e2695 Operator's Manual page 106

6.2.5.1 Edit the I/O Events table
In the I/O Events table, you set the timing for the following events to occur during a run:
• Changing the state of event switches
• Setting the column temperature
• Setting the sample compartment temperature
• Alerts
You can program up to 25 lines in the I/O Event table.
To enter event in the I/O Events table:
1. Press the Table screen key in the I/O screen to open the I/O Events table screen.
Figure 6–10: I/O Events table
2. Enter values in the I/O events table as appropriate, and then press Exit.
The following table describes the I/O Events table's parameters.
Table 6–9: I/O Events table parameters
Parameter
Time
Event type
Function
Determines the time after the
start of a run during which the
change is to occur. Press the
Clear key to select INIT.
Conditions in the INIT line
apply when the system is
initialized to a method, while
events at time 0.00 occur
immediately upon an injection.
Sets the type of event to occur. Switches 1 through 4
February 27, 2018, 715003794 Rev. C
Page 106
Value range
INIT, 0.00 to 999.99
in 0.01 min increments
Set Temp
Alert