4.
Confirm that the input to which the jumper wires are connected changes state (circles
change from empty to full) as the switch is toggled.
8.4.7
Keypad test
The keypad test tests the keypad keys. You press the key on the keypad and observe the key as it
changes appearance in the Keypad diagnostic screen. Run this test if you experience problems
with the keypad.
To perform the keypad test:
1.
In the Other Diagnostics screen, select Keypad, and then press OK. The Keypad diagnostic
screen appears.
2.
Follow the on-screen instructions to perform the test.
8.4.8
Display test
The display test tests the display screen by projecting test patterns on it. Run this test if you
experience problems with the separations module's display.
To perform the display test, select Display in the Other Diagnostics screen, and then press OK.
8.4.9
Carousel test
The Carousel test tests these components:
•
Vial sensor
•
Carousel ID sensor
•
Carousel drive
Run this test if you experience problems with the carousel carrier system.
To perform the carousel test:
1.
In the Other Diagnostics screen, select Carousel, then press OK.
2.
follow the instructions in the Carousel test screen.
February 27, 2018, 715003794 Rev. C
Page 165