Automatic Runs; System Controller Or No Interaction Mode; Controlled By Empower Software - Waters Alliance e2695 Operator's Manual

5

Automatic Runs

You can set up the separations module to make automatic runs when it operates as follows:
• In System Controller or No Interaction mode
•

Controlled by Empower software

• Controlled by MassLynx software
See "Operating configurations" on page 29
5.0.1

System Controller or No Interaction mode

Note: Local injections are not available when disabled from within Service Diagnostics.
If your HPLC system uses the separations module in a System Controller or No Interaction mode,
you perform an automatic run using a sample set or sample template stored in the separations
module. Chapter 6
templates. You run existing sample sets and sample templates from the separations module's
Main screen.
Figure 5–1: Main screen
5.0.2 Controlled by Empower software
If your HPLC system is controlled by Empower software, you perform an automatic run using a
project, instrument method, configured system, method set, and sample set stored in software. For
details on performing runs using Empower software, see the procedures in
runs under Empower software control" on page
explains how to create and store separation methods, sample sets, and sample
February 27, 2018, 715003794 Rev. C
Page 81
for details about separations module control modes.
86.
"Perform automatic