Neutral Indicator Light (Green) - Can-Am DS 450 2008 Shop Manual

CONTINUITY TEST
TAILLIGHT/BRAKE LIGHT GROUND CIRCUIT
CONTROL TO Taillight/brake
ACTUATE light connector
NONE Pin 1
(TAILLIGHT) (BLACK wire)
BRAKE LEVER Pin 3
(BLACK/GREEN
BRAKE PEDAL
wire)
vmr2008-027-006_b
TAILLIGHT/BRAKE LIGHT CONTINUITY TEST
If you do not obtain close to 0
light circuit, repair or replace wiring.
If you do not obtain close to 0
brake light circuits, refer to the
for brake lever and brake pedal switch testing and
replacement.
Taillight/Brake Light Bulb Replacement
Unscrew lens screws to expose bulb.
vmo2008-011-049_a
TYPICAL – TAILLIGHT ASSEMBLY
1. Screws
Push bulb in and hold while turning counterclock-
wise to release it from the socket.
Install the new bulb by first pushing it in, then turn-
ing it clockwise.
vmr2008-027
Set ignition switch to "ON" and test both the tail-
light and brake light functions.
NEUTRAL INDICATOR LIGHT
Resistance
(GREEN)
Neutral Indicator Light Operation
Close to 0
The neutral "N" indicator light is an LED that
comes on only when the vehicle is powered and
the transmission is in neutral. It is mounted in a
cluster (dashboard) just ahead of the fuel cap and
has no light test function.
1. Neutral (N) indicator light
2. Check engine indicator light
through the tail-
3. Low fuel level indicator light
The light receives power from the headlight power
through one of the
regulator and is activated by the neutral switch in
BRAKES
section
the transmission which provides a ground to the
light when the transmission is in neutral.
If the neutral indicator light does not come on, car-
ry out the following procedures.
Neutral Indicator Light Testing
If the neutral indicator light will not come on with
the transmission in neutral, first test the neutral
position switch as it is easily accessible. Refer to
the
If the neutral position switch tested good, remove
the indicator lights dashboard, refer to the
section.
Disconnect the neutral indicator light connectors.
Section 06 ELECTRICAL SYSTEM
Subsection 04 (LIGHTS)
vmo2008-011-028_b
GEARBOX
section.
BODY
263