Inspection; Engine Oil Pressure - Can-Am DS 450 2008 Shop Manual

vmo2008-011-099
STRAINER
Oil Tank Strainer Cleaning
Clean oil tank strainer with a parts cleaner then use
an air gun to dry it.
Oil Tank Strainer Inspection
Check condition of strainer mesh. Replace as re-
quired.
Oil Tank Strainer Installation
For installation, reverse the removal procedure.
Wipe out any oil spillage on oil tank.
Install a NEW O-ring on the outlet fitting.
Apply engine oil on O-ring.
Apply Loctite 243 (blue) (P/N 293 800 060) on out-
let fitting screws.
Carefully reinstall all previously removed parts.
CAUTION: Take care not to damage O-ring
while inserting outlet fitting into oil tank.
vmo2008-011-100_a
TYPICAL OIL OUTLET ASSEMBLY
1. Outlet fitting screw
2. Washer
3. Insert
4. Outlet fitting
5. O-ring
6. Strainer
vmr2008-012
Subsection 04 (LUBRICATION SYSTEM)

INSPECTION

ENGINE OIL PRESSURE

From LH side of vehicle, remove the plug screw
of timing chain tensioner and discard the sealing
washer.
vmr2008-012-101_a
vmr2008-012-032_a
1. Plug screw for timing chain tensioner
2. Sealing washer
CAUTION: Do not remove timing chain ten-
sioner.
Section 03 ENGINE
39