Can-Am DS 450 2008 Shop Manual page 210

Section 05 FUEL SYSTEM
Subsection 01 (ELECTRONIC FUEL INJECTION (EFI))
vmo2008-011-026_a
1. Vehicle serial number location
vmo2008-011-094_a
TYPICAL — VEHICLE SERIAL NUMBER LABEL
1. V.I.N. (Vehicle Identification Number)
2. Model number
Record engine serial number.
vmo2008-011-026_b
TYPICAL — ENGINE SERIAL NUMBER LABEL
1. E.I.N. (Engine Identification Number)
Enter data into ECM as detailed in
COLLECTED INFORMATION INTO THE ECM
low.
Entering the Collected Information
into the ECM
Use B.U.D.S. to enter the recorded data into the
new ECM.
In B.U.D.S., click the Read Data button to read the
new "empty" ECM.
190
vmr2006-012-100_aen
Go to the Vehicle tab and enter the information
you recorded previously.
– Vehicle (V.I.N.) number
– Engine number
NOTE: Do not enter the leading "M".
– Model number
NOTE: Do not enter leading or trailing 0s (zeros).
– Customer.
Go to the Setting tab.
Reset the Closed Throttle and Idle Actuator.
Refer to
vmr2006-014-084_aen
Click on the Write Data button.
ENTERING THE
be-
vmr2006-012-100_ben
Reinstall remaining removed parts.
Test run engine.
CLOSED THROTTLE RESET
above.
vmr2008-022