Can-Am DS 450 2008 Shop Manual page 173

vmr2008-012-012_a
1. Bearing bolt
2. Intermediate gear
Unscrew screws retaining the disengagement
gate to the crankcase.
vmr2008-018-022_a
1. Screws
2. Disengagement gate
Hold pawls and remove tooth segment.
CAUTION: Pawl springs are loaded and will
pop outside of tooth segment if pawls are not
held during tooth segment removal.
vmr2008-018-023_a
1. Tooth segment
2. Pawls
vmr2008-018
Subsection 10 (GEARBOX)
Unscrew and remove bearing pin.
vmr2008-018-024_a
1. Bearing pin
Insert a flat screwdriver in the slot of index lever.
Turn screwdriver counterclockwise and remove in-
dex washer.
vmr2008-018-025_a
1. Index lever
2. Index washer
Remove:
– Index lever screw
– Step ring
– Index lever
– Index spring.
Section 03 ENGINE
153