Can-Am DS 450 2008 Shop Manual page 363

vmr2008-033-049_a
1. Brake pedal spring
Remove pin securing brake pedal to master cylin-
der rod hook. Discard the cotter pin.
vmr2008-033-050_a
1. Brake pedal
2. Retaining pin
Remove brake pedal screw.
vmr2008-033-051_a
1. Brake pedal
2. Brake pedal screw
3. Washer
4. Shim
Remove brake pedal.
Brake Pedal Bearing Replacement
Using a punch, drive bearings out of frame.
vmr2008-033
Section 08 CHASSIS
Subsection 05 (BRAKES)
vmr2008-033-052_a
NOTE: If the inner bearing outer race stays inside
the frame, the swing arm removal is necessary.
Use a blind hole puller from the blind hole puller
kit (P/N 529 036 117) to extract the outer race.
529036117
vmr2008-033-053_a
1. Inner bearing outer race
Use the following setup to install bearings.
343