Can-Am DS 450 2008 Shop Manual page 248

Section 06 ELECTRICAL SYSTEM
Subsection 01 (IGNITION SYSTEM)
Disconnect the ignition switch connector.
vmr2008-137-001_a
DISCONNECT IGNITION SWITCH
Set the Fluke 115 multimeter (P/N 529 035 868)
to Vdc.
Measure the ignition switch input voltage as fol-
lows.
IGNITIONS WITCH INPUT VOLTAGE TEST
TEST PROBES
Pin C Battery
(BEIGE wire) ground
vmr2008-137-001_b
IGNITION SWITCH INPUT VOLTAGE TEST
If you do not obtain battery voltage, test the fol-
lowing:
20 A main fuse
228
vmr2008-026-001_a
1. 20 A main fuse
5 A ECM fuse
VOLTAGE
Battery voltage
vmr2008-026-002_a
1. 5 A ECM fuse
Wiring harness.
If the ignition switch input voltage is good, carry
out an ignition switch continuity test.
Ignition Switch Continuity Test
Set the Fluke 115 multimeter (P/N 529 035 868)
to
Measure the resistance through the ignition
switch between the following pins.
NOTE: Connector pin B is not used.
.
vmr2008-024