General; Inspection; Cooling System Leak Test - Can-Am DS 450 2008 Shop Manual

Section 03 ENGINE
Subsection 05 (COOLING SYSTEM)

GENERAL

During assembly/installation, use the torque val-
ues and service products as in the exploded
views.
Clean threads before applying a threadlocker. Re-
SELF-LOCKING FASTENERS
fer to
APPLICATION
at the beginning of this manual for
complete procedure.
WARNING
Torque wrench tightening
must strictly be adhered to.
Locking devices (e.g.: locking tabs, elastic
stop nuts, cotter pin, etc.) must be replaced
with new ones.
Hoses or cables removed or disconnected must
be installed and routed at the same place.
CAUTION: Locking ties removed during a pro-
cedure must be replaced and installed at the
same location.
Oetiker Clamp Replacement
To secure or cut Oetiker clamps, use Oetiker pliers
(P/N 295 000 070).
F01B03A
1. Cutting clamp
1. Securing clamp
54
LOCTITE
and
specifications
F01B05A
1. Securing clamp in limited access

INSPECTION

COOLING SYSTEM LEAK TEST

In order to avoid getting burned, do not re-
move the coolant tank cap or loosen the en-
gine drain plug if the engine is hot.
Remove access cover to reach coolant tank cap.
Refer to
1
vmo2008-011-061_a
1. Access cover
Remove coolant tank cap.
Install the test cap (P/N 529 035 991) on filler neck
of coolant tank.
Pressurize all system through coolant tank to
110 kPa (16 PSI) by using the pump included in
the vacuum/pressure pump kit (P/N 529 021 800).
1
WARNING
BODY section.
vmr2008-013