Can-Am DS 450 2008 Shop Manual page 308

Section 08 CHASSIS
Subsection 01 (WHEELS/TIRES)
vmr2008-028-019_a
1. Cotter pin
Unscrew the rear wheel hub nut.
vmr2008-028-020_a
1. 41 mm socket
2. Pry bar
Remove the flat washer.
vmr2008-028-021_a
1. Flat washer
2. Wheel hub
Pull rear wheel hub to remove it.
288
vmr2008-028-022_a
1. Wheel hub
2. Drive axle
Remove the conical washer.
vmr2008-028-023_a
1. Conical washer
Rear Wheel Hub Installation
Install conical washer with its flat side outward.
Apply CV grease (P/N 293 550 019) on drive axle
splines.
Install wheel hub. Align a wheel hub opening with
a cotter pin hole.
vmr2008-028-024_a
1. Wheel hub opening
2. Cotter pin hole
Install flat washer and nut.
Tighten wheel hub nut to 250 N•m (184 lbf•ft).
Further tighten nut until one of its grooves is
aligned with the cotter pin hole and hub opening.
vmr2008-028