Can-Am DS 450 2008 Shop Manual page 155

vmo2008-011-063_c
CLUTCH LEVER — PROPER ADJUSTMENT
A. 10 to 15 mm (3/8 to 5/8 in)
Tighten cable adjuster lock nut when proper ad-
justment is obtained.
Adjustment at Clutch Cover
CAUTION: When adjustment of the clutch re-
lease cover screw is needed, it means that
the clutch plates have worn. Therefore, it is
strongly recommended to take a few minutes
to inspect clutch plates condition.
Fully unscrew cable adjustment lock nut.
vmr2008-017-100_a
Fully screw and tighten clutch cable adjuster to
provide maximum free play.
Loosen cable adjuster lock nut.
Remove clutch cover access plug.
vmr2008-017
Subsection 09 (CLUTCH)
vmo2008-011-042_c
LH SIDE OF ENGINE
1. Access plug
Install the clutch adjustment wrench (P/N 529 036
076) onto lock nut.
529036076
vmo2008-011-071_a
1. Lock nut
Hold adjustment screw using a flat screwdriver,
then loosen lock nut counterclockwise.
Section 03 ENGINE
135