Can-Am DS 450 2008 Shop Manual page 243

WARNING
Prior to disconnecting the fuel rail quick dis-
connect fitting, ensure engine and exhaust
system are not hot.
Wrap a rag around the fuel hose at the quick dis-
connect fitting.
vmr2008-022-039_A
Disconnect fuel line at quick connect. Refer to
FUEL PUMP
in this section.
Remove the two side frame members, refer to the
FRAME
section.
vmr2008-022-051_b
SIDE FRAME MEMBER (RH SHOWN)
While supporting fuel tank, remove the top LH fuel
tank mounting screw.
vmr2008-023
Section 05 FUEL SYSTEM
Subsection 02 (FUEL TANK/FUEL PUMP)
vmr2008-023-010_a
TOP LH FUEL TANK MOUNTING SCREW
Carefully lower the fuel tank until the filler neck
clears the frame top plate, then pull it out the RH
side.
Fuel Tank Inspection
Inspect fuel tank for any damages or cracks which
may result in fuel leaks.
Inspect tank attachment points for damage.
WARNING
If cracks and other damages which may re-
sult in fuel leaks or tank not being secure are
found, replace fuel tank.
Fuel Tank Installation
Reverse removal procedures however, pay atten-
tion to the following.
Torque fuel tank mounting screws as specified in
exploded view.
Torque side frame member mounting screws as
specified in the FRAME
Refuel tank and ensure there are no leaks by per-
FUEL TANK LEAK TEST
forming the
PUMP PRESSURE TEST
tion.
section.
FUEL
and the
as described in this sec-
223