Clutch Cable; Clutch Lever - Can-Am DS 450 2008 Shop Manual

Tighten clutch release cover screws in a crisscross
sequence.
Install shifter.
CLUTCH ADJUSTMENT
Perform the
dure at the beginning of this section.

CLUTCH CABLE

Clutch Cable Removal
At Engine
CLUTCH RELEASE COVER
Remove the
cedure above in this section.
Disengage clutch cable.
vmr2008-017-101_a
At Handlebar
Remove the front body assembly. Refer to
section.
Loosen cable adjuster lock nut.
vmo2008-011-063_a
1. Lock nut
Turn cable adjuster until proper dimension is ob-
tained.
vmr2008-017
, see proce-
vmo2008-011-063_b
1. Cable adjuster
, see pro-
Detach clutch cable end from clutch lever.
Cut all locking ties securing the clutch cable.
Remove the cable from the vehicle noting its cor-
rect routing.
Clutch Cable Installation
The installation is the reverse of the removal pro-
cedure.
Proceed with the clutch cable adjustment.

CLUTCH LEVER

Clutch Lever Removal
NOTE: If the clutch lever is not replaced, omit the
next steps concerning the clutch switch connec-
tors and clutch cable removal.
Remove the front body assembly to reach clutch
switch connectors. Refer to
Unplug clutch switch connectors.
BODY
vmr2008-017-070_a
1. Clutch switch connectors
Loosen cable adjuster lock nut.
Section 03 ENGINE
Subsection 09 (CLUTCH)
BODY
section.
139