B.u.d.s. Software - Can-Am DS 450 2008 Shop Manual

Section 04 ENGINE MANAGEMENT SYSTEM
Subsection 02 (COMMUNICATION TOOLS/B.U.D.S. SOFTWARE)
vmr2008-020-002_a
Connect remaining connector to MPI-2 connector.
vdd2006-001-151
Connect remaining MPI-2 connector to the USB
port of a PC (personal computer).
mmr2006-079-200
Use B.U.D.S. software as described further in

B.U.D.S. SOFTWARE

.
B.U.D.S. SOFTWARE
B.U.D.S. (Bombardier Utility and Diagnostic Soft-
ware) is designed to allow electrical component
inspection, to diagnose and monitor components
and to carry out settings such as the closed throt-
tle and idle actuator.
168
For more information pertaining to the use of the
B.U.D.S. software, use its help which contains de-
tailed information on its functions.
Ensure the appropriate connections are done for
B.U.D.S.
Ensure to use the latest B.U.D.S. version compat-
ible with the DS 450 available on BOSSWeb.
Turn ignition switch ON and set engine stop
switch to RUN to activate the communication.
Start B.U.D.S.
Select the protocol Kw2000 (500K).
vmr2008-133-003
Ensure the status bar shows Kw2000 500K with
the number 1 to its right. If not, refer to
NICATION PROBLEMS
NOTE: Number 1 means that one "ECU" is con-
nected (ECM).
vmr2008-020-004
CONNECTION SUCCESSFUL
Transfer data from the ECM to B.U.D.S. by clicking
the Read Data button in B.U.D.S.
vmr2006-012-100_aen
When finished, transfer data from B.U.D.S. to the
ECM by clicking the Write Data button in B.U.D.S.
COMMU-
below.
vmr2008-020