Engine Stop Switch - Can-Am DS 450 2008 Shop Manual

IGNITION SWITCH CONTINUITY TEST
IGNITION
IGNITION
SWITCH
SWITCH PINS
POSITION
Pins A to F
OFF Pins C to D
Pins E to F
Pins A to F
ON
Pins C to D
(w/lights)
Pins E to F
Pins A to F
ON
Pins C to D
(w/o lights)
Pins E to F
vmr2008-137-001_c
IGNITION SWITCH CONTINUITY TEST
Replace switch if defective.
If the ignition switch tested good, carry out a con-
tinuity test of the engine stop switch.
Ignition Switch Removal
Remove the front body assembly, refer to the
BODY
section.
Disconnect the ignition switch connector.
vmr2008-024
RESISTANCE
Infinite (OL)
0.2 ± 0.2 max.
0.2 ± 0.2 max.
Infinite (OL)
Infinite (OL)
0.2 ± 0.2 max.
Infinite (OL)
TYPICAL
1. Disconnect ignition switch connector
While holding switch with one hand, unscrew the
ignition switch retaining nut with the other.
vmr2008-137-002_b
TYPICAL
1. Remove retaining nut
Ignition Switch Installation
For installation of the ignition switch, reverse the
removal procedure.
Torque the switch retaining nut to 4 N•m
(35 lbf•in).

ENGINE STOP SWITCH

Engine Stop Switch Operation
The engine stop switch functions as an engine
shutoff switch for a normal shutdown or for an
emergency situation. It can be quickly activated
without letting go of the handlebars.
Section 06 ELECTRICAL SYSTEM
Subsection 01 (IGNITION SYSTEM)
229