Rear Sprocket Hub - Can-Am DS 450 2008 Shop Manual

Section 07 DRIVE SYSTEM
Subsection 01 (DRIVE CHAIN/REAR AXLE)

REAR SPROCKET HUB

Rear Sprocket Hub Removal
CAUTION: Removing rear sprocket hub from
rear axle will permanently damage the hub
splines. Do not remove hub needlessly.
REAR SPROCKET
Remove
section.
REAR AXLE
Remove from vehicle, see procedure
in this section.
Using an appropriate steel tube as a pusher, press
the hub down approximately 2 mm (.080 in) to
allow C-clip removal.
NOTE: Heat sprocket hub in the center area to
allow hub displacement.
vmr2008-032-051_a
1. Rear sprocket hub
2. Steel tube used as a pusher
3. C-clip
Pull tube out and remove C-clip.
WARNING
Wear gloves to handle the parts to protect
your hands from the heated parts.
Turn rear axle upside down.
Press the hub out of rear axle.
280
, see procedure in this
vmr2008-032-052_a
1. Steel tube used as a pusher
Discard hub.
Remove and discard the O-ring.
vmr2008-032-053_a
1. O-ring
Rear Sprocket Hub Installation
CAUTION: Never reinstall a removed sprocket
hub. Always install a new one.
Clean rear axle splines with pulley flange cleaner
(P/N 413 711 809).
Install a NEW O-ring on rear axle and properly seat
against the axle flange.
vmr2008-032-054_a
1. New O-ring
2. Axle flange
vmr2008-032